Reasons Why Your Nissan Qashqai Key Fob Won't Work
The Qashqai has a distinct SUV feel due to its larger dimensions, and the wheel sizes of 19 inches in Ti and ST-L models may be a bit stiff at times. The front tyres of the Qashqai can lose grip on rough surfaces, and its CVT could occasionally exhibit wrist-flexing torque steer.
www.thekeylab.co.uk is usually caused by dead batteries, which can be replaced in a matter of minutes. Make sure the replacement battery is of the same size, voltage and specifications.
Water Damage
Water damage is among the most common causes for a Nissan keyfob to display the "key ID is incorrect" message. The key fob comes with rubber seals that protect the chip inside, but long-term exposure to moisture could cause it to stop working properly. This is usually the case when you've dropped your key fob in the ocean or into a swimming pools, but it could occur if it becomes wet from soapy hands or rain.
If your key fob has been exposed to water for a long period of time then you might need to clean it with isopropyl, or an electronic cleaner. Alternatively, it might require the attention of a professional for repair or replacement.
If your key fob has to be replaced, it's a relatively simple procedure. First, make sure you have a multipack of the correct battery (CR2032 3V). Then, open the back and front cases using the help of a small screwdriver. You'll need to take out the clips that hold the metal together and push out the old battery, then insert the new one. Reassemble the fob and replace the mechanical key. Check that it works correctly. If it does not, you will need to take it to your local Nissan dealer or a professional auto locksmith to fix the chip that controls the key. Fortunately, the chip is not often damaged by water exposure and this shouldn't be a huge expense.
Dead Coin Battery
The coin battery is another common reason that your Nissan Qashqai remote key fob might not function. The batteries typically last between 3-5 years but can go bad over time, particularly if the fob is dropped frequently. You can replace the battery, however, make sure it's the same voltage and the same size as the original. If you use another battery, it may cause the key to have an invalid key ID that could hinder it from connecting to your vehicle.
The best method to replace the coin battery on the Nissan Qashqai key fob is by prying open the fob with the small screwdriver with a flat-head. The screwdriver should be inserted into tiny notch at the bottom of the fob, and move it around to separate the two parts of the key fob. Then, take out the old CR2025 button cell battery and insert an alternative one after taking note of its location in the fob.
Check the terminals for water damage or dirt before installing the new battery. If there is clean the terminals with a small amount isopropyl ethanol. Make sure that the pole cables are connected correctly. They should be connected to the negative and the positive poles of your battery.
Fault Diagnosis
If your Nissan Qashqai key fob stops working after exposure to pure tap water or rain it could be an indication of a chip problem inside the. Change the battery won't fix this issue, and you'll have to buy a new key fob. If you dropped the key fob on the ground and it stopped working instantly, this is most likely due to the damage to the internal chip. If you clean the chip using isopropyl ethanol and paper towel, then replace it in the key fob, it is possible to usually get it working again.
Key ID Incorrect is a common error that can be seen on the dashboard of your car. This means that the car cannot recognize the key fob and not allow it to start the engine. The issue could be caused by a variety of things, including water damage, undetectable issues in the key fob's circuitry or RFID interference.
The key fob will stop working in the event that the batteries with 12 volts are dead or don't provide enough electrical current. This will affect the remote keyless system and central locking of your Nissan Qashqai, as well as preventing you from starting the engine using the key fob (if equipped with Intelligent Key). Check the battery in the key fob if you're not able to lock or unlock your door by hand. Try re-inserting the battery to reset the transmitter.
Reprogramming
If the key fob was not submerged into saltwater it should be restored to its original state with a simple wash of clean water. You can also clean the electronic chip by using isopropyl or electronic cleaner. If none of these works then you might need to replace the key fob.
If your Nissan Intelligent Key still does not function, there could be a connection problem between it and your vehicle. To relink it, start by turning the key in the ignition, without turning on the car. Continue doing this until you see the danger lights flash twice. Then, turn the vehicle off and remove the keys.
Then, open the fob compartment in your vehicle. It's usually on a door jamb or driver's door handle. Find the small button labeled "program" and press it. Once the process has been completed, you should hear the sound of a chime.
It's time to put your Intelligent Key to the test. Make sure you press all the buttons on the key while standing at a distance from the vehicle. If the lights flash and the horn beeps it means that the key is successfully linked to the Nissan. You can also test it close to the Nissan.